Method 1: Soak the adhesive part with acetone until the rubber is dissolved into a paste, then use bamboo strips to roll cotton and wipe it in the acetone solution until the rubber is completely wiped off. (Used for severe adhesives)
Method 2: Sprinkle boiled water or acetone with facial tissue or a piece of cloth to wipe off the glue sticking to the mold and clean it. Note that this method is used on the etched part of the bottom shell, and the highlight position and the surface shell are not available Rags, do not wipe with force. (Used for medium viscose)
Method 3: Use a toothbrush and a small amount of steel grit to wipe the whitish parts for two minutes, and then clean it.
Shiny)
Method 4: Use a toothbrush and full-effect metal care cream to wipe the white areas for two minutes and then clean them. (The bottom shell is shiny and etched)
Method 5: Spray the mold washing water on the facial tissue and gently wipe the white areas, and then clean them. (Bottom shell erosion
Shiny)
Method 6: Rinse with mold washing water. (Emergency measures for burst water pipes)
Method 7: Use a cotton pad with 3.5# and 3# diamond cream to wipe the mold, and then use a cotton pad with 1# diamond cream to trim the light, pay attention to a little dark power, do not move too fast, and clean after finishing. (Used in (White print, strain on the inner and outer frames)
Method 8: Use a cotton pad with 3.5# and 1# diamond cream to mix use. Pay attention to a little dark force when wiping the mold. The pressure should not be too large and the action should not be too fast. Then the cotton pad is matched with 1# diamond cream to polish. Then clean Just clean. (Used on the white print, the inner and outer frames are strained)
Method 9: Use a cotton pad with 1# diamond cream to wipe lightly with a little dark force, not too fast, and then clean. (Use on oil or water points)
Method 10: Spray the green anti-rust agent on the white printing position, wipe it with a cotton pad or facial tissue with a little dark force, and then clean it. If the finish is not enough, then use a cotton pad with 1# diamond cream to polish, (used in white Printed on)